Cornelius QUEST 4000 Service Manual download pdf (Page 5)

Quest Installation and Service Manual

Revision B - 2 - 720506904

INSTALLATION

RECEIVING

Each unit is completely tested and inspected before shipment. At time of shipment, the carrier

accepts the unit and any claim for damage must be made with the carrier.

Upon receiving from the carrier, please inspect the carton for visible damage. If damage exists,

have the carrier make a note on the bill of lading and file a claim with the carrier.

UNPACKING

• Remove staples securing carton to pallet.

• Lift carton up and off of unit.

• Remove inserts and shipping bag.

• Open upper cabinet door and remove installation kit.

• Remove bolts securing unit to pallet.

• Lift unit off of pallet.

NOTE: Do not lay the unit on sides or on the back. This may cause vital oils to drain

from the compressor resulting in damage during start-up and consequently void-

ing the warranty.

COUNTER LOCATION

Select a location in a well ventilated area, close to a grounded

electrical outlet. If possible do not place the unit close to hot and/or

steaming machines.

The minimum airflow clearance is: 4” (10.16 cm) in back and 12”

(30.48 cm) on top and open to the front.

IMPORTANT: Condenser air is drawn in from the bottom of the

rear panel and discharged out the top of the rear panel. Failure

to maintain clearance space will reduce capacity of the unit

and cause premature compressor failure.

Typically the dispenser is placed directly on the counter and a food

grade silicone sealant applied around the base. However, 4” legs

that screw into the base of the unit are provided. This eliminates the need to seal the unit to the

counter.

FILLING THE ICE BATH

The ice bath holds approximately 3 gallons (11.4 liter) of

water. The fill tube is located behind the front splash plate

and capped with a 3/8” (0.95 cm) male flare connector. Prior

to attaching the water supply line to the dispenser, use it to

fill the ice bath by attaching it to the connector on the fill tube.

1 2 3 4 5 6 7 8 9 10 ... 46 47

No comments

Cornelius QUEST 4000 Service Manual Page 5