Cornelius JetSpray JS7 Owner's Manual download pdf (Page 12)

JetSpray JS7 Owner’s Manual

Figure 8.

B. Remove pinch tube from the plastic bag and wash it.

C. Before installing, wet the bowl spout surface and pinch tube. Push back the handle until it stops.

D. Carefully insert pinch tube into the bowl spout opening and on into the lower opening of the handle sup-

port spout (See Figure 3.). Make sure the end of the tube does not get caught on the edge above the

handle support spout opening. Pull the end of the tube to seat it firmly into the bowl spout seat. Make

sure the tube is free of wrinkles and extends below the support spout about a 1/4 inch. (See Figure 9.)

Figure 9.

Operating Procedures

1. Follow beverage manufacturer's directions in filling bowls. To aid in filling, the bowls have gallon and liter

markings up the center of the front wall. Gallons are on the right and liters are on the left.

2. Turn on the spray switch. Product should be cold enough to serve in approximately 2 hours.

NOTE: The unit should be left ON 24 hours a day to insure efficient operation and consistent product

quality.

3. The thermostat is preset at the factory and should not normally be reset by owner. If unit temperature is not

correct, a service technician should be contacted.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18

No comments

Cornelius JetSpray JS7 Owner's Manual Page 12