Cornelius 10 User Manual download pdf (Page 31)

300381000 26

CARBONATED WATER CIRCULATING PUMP MOTOR LUBRICATION

(see applicable Figure 5 or 6)

Carbonated water circulating pump motor bearings must be oiled periodically. Refer to oiling instructions on

motor. DO NOT OVER OIL.

ADJUSTMENTS

NOTE: To readjust CO

regulator to a lower setting, loosen adjusting screw lock nut, then turn screw to

the left (counterclockwise) until pressure gage reads 5-psi lower than new setting will be. Turn

adjusting screw to the right (clockwise) until gage registers new setting, then tighten lock nut.

PRIMARY CO

REGULATOR

(see Figure 2)

Adjust primary CO

regulator on CO

cylinder to a minimum nominal setting of 120-psi or 24-psi higher than

highest setting required by the secondary CO

regulators. Loosen CO

regulator adjusting screw locknut. Turn

adjusting screw to the right (clockwise) until regulator gage registers nominal 120-psi, then tighten adjusting

screw locknut.

WATER LINE TO TANK

DOUBLE LIQUID

CHECK VALVE

WHITE TAPERED GASKET

SAFETY THERMOSTAT

(P/N 318040000)

ELBOW

PUMP TO MOTOR COUPLING

WATER PUMP

WATER

STRAINER SCREEN

(P/N 315348000)

O--RING (P/N 315349000)

SCREEN RETAINER

FIGURE 8. WATER STRAINER SCREEN AND LIQUID DOUBLE CHECK VALVE

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 51 52

No comments

Cornelius 10 User Manual Page 31