Cornelius ENDURO-150 Installation Manual download pdf (Page 7)

Ice/beverage Dispenser Installation Manual

INSTALLATION INSTRUCTIONS

INSTALLATION

WARNING:

TO THE INSTALLER.

It is the responsibility of the Installer to ensure that the water supply to the dispensing equipment is provided with

protection against backflow by an air gap as defined in ANSI/ASME A112. 1.2-1979; or an approved vacuum

breaker or other such method as proved effective by test and must comply with all federal state and local codes,

failure to comply could result in serious injury, death or damage to the equipment.

Water pipe connections and fixtures directly connected to a potable water supply shall be sized, installed, and

maintained according to Federal, State, and Local laws.

1. Locate the dispenser indoors on a level counter top.

A. LEG OPTION

Unpack the four (4) legs and install them into the threaded holes provided in the bottom of the unit.

The installer must provide flexibility in the product and utility supply to permit shifting the position of the

dispenser sufficiently to clean the area beneath it.

B. COUNTER MOUNTING

The ice dispenser must be sealed to the counter. The template drawing (see Figure 3) indicates where

openings can be cut in the counter. Locate the desired position for the dispenser, then mark the outline

dimensions on the counter using the template drawings. Cut openings in counter.

Apply a continuous bead of

NSF International

(NSF) silastic sealant (Dow 732 or equal) approximately

1/4--inch inside of the unit outline dimensions and around all openings. Then, position the unit on the counter

within the outline dimensions. All excess sealant must be wiped away immediately.

2. The beverage tubes, drain tube and power cord are routed through the large opening in the bottom of the unit.

See the MOUNTING TEMPLATE (Figure 1) for locating the required clearance opening in the counter for these

utility lines.

3. DRIP TRAY DRAIN ASSEMBLY (see Figure 2): Route the drain tube to an open drain with the end of the tube

above the “flood” level of the drain. Use the tubing, fittings, clamps, and insulation provided with the Dispenser

to assemble the drain. The completed drain line must pitch continuously downward and contain no “traps” or

improper drainage will result.

4. Connect the beverage system product tubes as indicated in the Beverage System Schematic. This workshould

be done by a qualified service person.

NOTE: See applicable Plumbing Diagram (see Figure 5 or 6) or Decal on the lower front panel of the unitfor

the location of syrup and water connections.

5. Clean the hopper interior (see CLEANING INSTRUCTIONS in Owner’s Manual).

WARNING:

This unit must be grounded to aviod possiable fatal electrical shock on serious injury to the opertor. The unit power

card is equiped with a three prong plug. if a Three-hole (grounded) outlet is not avilable and use an approved method

to ground the unit. Failure to comply could result in serious injury, death or damage to the equipment.

6. Connect the power cord to a 120 volt, 60 cycle, 3-wire grounded receptacle. For 220--240 volt International

units, a 3--wire power cord is provided. An adapter plug for the particular country will need to be provided by the

Installer.

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

Comments to this Manuals

No comments

Cornelius ENDURO-150 Installation Manual Page 7

Comments to this Manuals

Related products and manuals for Water dispensers Cornelius ENDURO-150