Cornelius 10 User Manual download pdf (Page 32)

27 300381000

Index

No.

Part

No.

Name

1 317963000 Housing

2 312415000 Flat Washer, Stainless Steel

3 *312418000 Ball Seat (quad ring)

4 312419000 Ball

5 312196000 Spring

6 317965000 Retainer

* Install new ball seat at each servicing.

FIGURE 9. LIQUID CHECK VALVE ASSEMBLY

SECONDARY CO

REGULATORS

(see Figure 2)

Carbonator Secondary CO

Regulator.

Adjust carbonators secondary CO

regulator to a nominal 90-psi. Loosen CO

regulator adjusting screw locknut.

Turn adjusting screw to the right (clockwise) until regulator gage registers nominal 90-psi, then tighten adjusting

screw locknut. CO

PRESSURE TO CARBONATORS MUST NOT EXCEED 125-PSIG.

Sugar Syrup Soft Drink Tanks CO

Regulator.

Adjust sugar syrup soft drink tanks secondary CO

regulator at 40-psig for syrup lines up to10-feet in length plus

one pound for each additional length of 10-feet, plus one pound for each 2-feet of vertical lift. For example: if

syrup line total length is 30-feet and total vertical lift is 6-feet, then 40-psig+ 2-psig (1-pound for every10-feet of

length over10-feet which is 20-feet)+3-psig (1-pound for every 2-feet of vertical lift which is 6-feet); total equals

40+2+3=45-psig CO

regulator setting.

Low-Calorie (diet) Syrup Soft Drink Tank CO

Regulator.

Adjust low-calorie (diet) soft drink tank secondary CO

regulator for low-calorie drink at 10-psig for syrup lines

up to 30-feet in length. Syrup lines longer than 30-feet in length may require a slightly higher CO

regulator

setting to 12-psig maximum. Excessive CO

pressure may cause low-calorie syrup carbonation resulting in

foam.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 51 52

Comments to this Manuals

No comments

Cornelius 10 User Manual Page 32

Comments to this Manuals

Related products and manuals for Ice cube makers Cornelius 10