Cornelius 000 PLUS Manual download pdf (Page 9)

®

CLASSIC 1000

REMOTE COOLER

8

5. FAULT FINDING

5.1 AIR COOLED MODEL

PROBLEM

No Product.

Product too cold.

Product

consistently too

warm.

Product too

warm after a

period of time.

Product too

warm during

peak periods.

ACTION

Check and correct.

Check and replace thermostat

if faulty.

Reduce the number of taps per

product.

Fit shorter coil.

Check fuse, plug and mains

switch.

Switch to ice bank.

Turn thermostat down.

Replace.

Replace base.

Plug pump into socket on the

base.

Replace.

Check for kinks. Clear out any

debris in the water recirculation

pipes.

Fit longer coil.

Check for space around the

cooler and airflow obstruction.

Clear and clean the condenser

fins.

Replace.

Replace base.

Reduce the number of products

on the cooler. Fit further cooler

if necessary.

Reduce the temperature of

product storage area.

POSSIBLE FAULT

Dispense system faulty.

Product frozen in coil.

Long soak time in coil

and/or python.

Coil too long.

No ice bank or water

bath too warm.

No water being

recirculated through

python.

Product coil too short.

Insufficient ice being

produced or being

produced very slowly.

Throughput too high.

POSSIBLE CAUSE

Is ice bank too large?

Low throughput.

Incorrectly specified.

Fuse blown or no electrical

supply.

Water bath thermostat used

but ice bank thermostat

needed.

Water bath thermostat set

too high.

Thermostat failed.

Refrigeration system failed.

Water recirculation pump

not plugged in.

Water recirculation pump

failed.

Blockage in python.

Incorrectly specified.

Poor airflow through the

condenser.

Condenser fan failed or

operating incorrectly.

Refrigeration system fault.

Too many coils in the cooler

for such a high demand.

Product inlet temperature

may be too high.

▼

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 20 21

Comments to this Manuals

No comments